https://www.4shared.com/zip/ZJNfFyGAiq/MRD-LX1F_MRD-LX2_FRP_Unlock.html?
dl nyo po..the gamit ka cm2mt2..
gayahin nyo nalng sa pict..auto pick namn xa..
heto testpoint..dapat walang batttery pagka connect sa pc
click frp reset nalng sa cm2..
finished product
nka locked ang unit sa T-mobile..
kaya try nck..
nag download ng reset sa nck..kaya ibahagi q nalng..
iflash nyo nalng po ang firmware...cpu neto ay MT6572 lang namn..pero nck or sigma ang merong support..
dapat nka fullflash po...mag foformat po ng partion then magkakaerror..
then hang na sa...
nka hello na po ang unit..
so bypassed tayo..
tools:usb cable
arduino / checkm8a5 program
ideputa software
sundin lang po ang instruction sa ideputa
https://ibb.co/rs6fsbm
duplicate url finder
then
kung nka PWNED na..click detect device and click ipad mini to start bypass...
full dead ang unit..kaya pull out q ang shorted...shorted ang PA..ngunit walang pamalit
PA number RDA 6232
make this jumper nalang..fried and tested
finished product
RTO ng other tech..nka ilang palit na ng touch screen pero ayaw talaga mag work...kaya banatan q...
check q all lines ng touch connector ok namn lahat...kaya voltage check..drop VCC ng touch ic kaya...try hanap ang salarin..
replace nyo yan..fullshorted ang pinakamaliit na caps
jan sa area na...
may pattern po ang unit pero hnd mkapasok sa recovery dahil ang ang nakalagay CUSTOM BINARY BLOCK BY FRP (secure fail:recovery)
kaya try mag flash ng combi file..pero error..pit file error..try q mag flash sboot pero parin..
kaya heto ang solution open ang UMT GSM..then select samsung click...
baka may maencounter kayo..ayaw ma touch..palit touch..failed parin..check terminal kung open traces..wala nmn akong nakita..check voltage missing 2.8 volts..kaya heto nalng solution..jump nyo nalng po..ika 7 pin ng LCD connector..papunta sa 2V8 ng terminal ng touch screen..
ayaw mag charge ng unit kapag nka off..hnd lumabas charging indicator...pero kapag nka on ng chacharge xa..pero ayaw lang lang tumass ng percent charge nya..kaya heto solution
just replace po yung nka red na IC na yan...
heto result nyan..
...nag update c tomer ng cp nya..ayon hang nalng..medyo risky c unit..baka ma todas
kaya try q UMT formatfs done pero hang parin..kaya buck up then flash..ayon n deado sa UMT..
try q balik buck up..success..pero dead parin..nka 9008 mode..
then try CM2,,ayon na dale..success buhay unit...then...
water damage po ang unit..kaya konting linis sa curroded part..pero same parin...kaya try q tirahin backlight section..hndi namn na bigo...
check ang replace po yung nka yellow..backlight ic then schotsky diode...
finish product
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.