- Joined
- May 9, 2019
- Messages
- 83
P30 (ELE L29)
EDL POINT:
Tools:
1. UMT Dongle
2. Tweezer
3. USB Data Cable
Procedure: (NOTE: REMOVE BATTERY)
1. Open UMT HST
2. Insert type C cable to the phone
3. Use tweezer for TP
4. Insert the data cable to the system unit in order to detect (NOTE: If it is detected already proceed to step 5)
5. Platform Kirin_980
6. Reset FRP
7. Execute
Logs:
EDL POINT:
Tools:
1. UMT Dongle
2. Tweezer
3. USB Data Cable
Procedure: (NOTE: REMOVE BATTERY)
1. Open UMT HST
2. Insert type C cable to the phone
3. Use tweezer for TP
4. Insert the data cable to the system unit in order to detect (NOTE: If it is detected already proceed to step 5)
5. Platform Kirin_980
6. Reset FRP
7. Execute
Operation : Reset FRP
Searching for COM1.0 Device...Found!
COM9 : HUAWEI USB COM 1.0 (COM9)
Opening Port...OK
Platform : Kirin_980
Sending Loader...[1]..[2]..[3]..Done
Reading Partition Table...Done
Erasing FRP Data...Done
Hold power button to reboot device.
Operation Finished.
UltimateHST v0.2
DONE.
Note: If the device manager ask for driver just install the huawei usb com 1.0 driver. In my case I disable the driver signature first cuz I cannot install the driver.
