Sammy
Premium 2024
HOW TO - Flash a Rockchip Device
based for RK3188 RK3066 RK2928 RK2918with an update.img File.
by mrkus21 on MK808B (for Example)
This is only the easy Way which means, you don´t need to use a Hardware Reset Button...
1. Install the Rockchip Driver on your PC. Download the Rockchip BatchTool and open it.
You can find everything you need here: http://vondroid.com/forums/rockchip.257/
2. Boot up your Device (MK808B) If your Device did not boot anymore, go to the End of this Guide and do it the Hard Way !
3. Go into Settings Menu --> Storage and in there to the Settings on Top of the Right Edge.
by mrkus21 on MK808B (for Example)
This is only the easy Way which means, you don´t need to use a Hardware Reset Button...
1. Install the Rockchip Driver on your PC. Download the Rockchip BatchTool and open it.
You can find everything you need here: http://vondroid.com/forums/rockchip.257/
2. Boot up your Device (MK808B) If your Device did not boot anymore, go to the End of this Guide and do it the Hard Way !
3. Go into Settings Menu --> Storage and in there to the Settings on Top of the Right Edge.
4. Then make sure that you have checked the "Mass Storage Device"
5. After that go to Settings Menu --> USB and click "Connect to PC"
6. Open the RockchipBatchTool and after "Connect to PC" the RKBatchTool should turn into Pink.
7. Use the FW Path to choose your right Firmware you want to flash.
7. Click on the "Switch" Button to turn the Device into Flash Mode. After that your Light should turn from Pink into Green, then you are in Flash Mode.
8. Click on "Upgrade" to begin flashing your Device... Note: Some Devices you need to click "Restore" for an Update... just try it.
9. Your Device will be formatted by the RKBatchTool, thats ok. After this the RKBatchTool begins to Download the Firmware to your Device....
10. Please be patient, this could take a while. Don´t pull out the Power or OTG Cable until this has finished. Otherwise you can brick your Device ! After Downloading the Firmware the RKBatchTool checks the Firmware again to make sure your Flash has been successfully made. After the RKBatchTool has finished, it should look like this:
11. Congratulations, your Flash has finished without Errors.
12. After this your Device will boot. This also can take a while on the first Boot. Be patient !!!
13. Check again if your flash has worked, go into Settings Menu again and click on "Device Info" at the Bottom.
There you can see your Firmware, Build and Kernel Version of your Device.
I hope this Guide is useful for you all.
original link so you will be able to see larger image http://vondroid.com/threads/how-to-flash-a-rochchip-device.7373/#.VYo-9EYtk3h