Hindi ko ito na include sa module. Ito ung fast track ko ng test point during diagnose...
Note: 75 percent applicable sa mga units na normal ang 3v 5v ALW.. hndi naka SUS UNG 3V OR 5V. PWEDI NIYO ETRY.
HERE IT IS IN ORDER:
1. Check 19v from first and 2nd mosfet
2. Check 3v and 5v coil
3. Check 3.3v at clock and data of battery terminal - ( hinde mo kailangan makabisado kung saan) clue magkatabi lang sila ng 3v pin
4. Check 3.3v sa power button. 1 method is this - connect red probe sa positive then yung black sa grnd press power switch button once nag Zero upon pressing at once nirelease mo ang pressing ng power switch at bumalik sa 3.3v -meaning good ang switch or gamit ng DC Bench makikita mo dun kung nag response ang once na ipress mo ang power switch.
5. If all signals are okey normal and present from step 1 to 4 then proceed sa testpoint
- hanapin ang pin 8 ng eeprom chip (bios) it must have 3.3v or 1.8v
6. If Step 1 to 5 is good and present, The Next step is to flash the bios chip.
Pag nagawa na ang Step 6 Ang Probable defect are
a) EEPROM IC
b) SIO
c) PCH
Magic teknik: Reheat ng kaunti lang muna ung SIO or iresolder mo ang mga pins. Prone to cold lead ang SIO sa sobrang dami pins nya at trabaho
Note: Wag kayo mag proceed sa next step pag wala ung current. Matic na un. START troubleshooting sa signal na missing sa step
Note: 75 percent applicable sa mga units na normal ang 3v 5v ALW.. hndi naka SUS UNG 3V OR 5V. PWEDI NIYO ETRY.
HERE IT IS IN ORDER:
1. Check 19v from first and 2nd mosfet
2. Check 3v and 5v coil
3. Check 3.3v at clock and data of battery terminal - ( hinde mo kailangan makabisado kung saan) clue magkatabi lang sila ng 3v pin
4. Check 3.3v sa power button. 1 method is this - connect red probe sa positive then yung black sa grnd press power switch button once nag Zero upon pressing at once nirelease mo ang pressing ng power switch at bumalik sa 3.3v -meaning good ang switch or gamit ng DC Bench makikita mo dun kung nag response ang once na ipress mo ang power switch.
5. If all signals are okey normal and present from step 1 to 4 then proceed sa testpoint
- hanapin ang pin 8 ng eeprom chip (bios) it must have 3.3v or 1.8v
6. If Step 1 to 5 is good and present, The Next step is to flash the bios chip.
Pag nagawa na ang Step 6 Ang Probable defect are
a) EEPROM IC
b) SIO
c) PCH
Magic teknik: Reheat ng kaunti lang muna ung SIO or iresolder mo ang mga pins. Prone to cold lead ang SIO sa sobrang dami pins nya at trabaho
Note: Wag kayo mag proceed sa next step pag wala ung current. Matic na un. START troubleshooting sa signal na missing sa step
Last edited: