[ OPPO MTK ] DEAD /LONG VIBRATE ONLY after flash [ FINAL SOLUTION ] no need to replace emmc
alam ko po marami na sa mga master natin ang nakaka alam nito, ayaw lang i post para iwas PD, kaya naman pakiusap po, kunting pagpapahalaga lang po sa ating hanap buhay.
TESTED SOLUTION FOR MTK OPPO DEVICES LIKE A11W, R831K, R1001, R2001,R827, R1201 AND OTHER OPPO MTK DEVICE
TOOLS NEEDED
Z3X EASY JTAG WITH DIRECT EMMC ADOPTER
MAGNETIC WIRE OR JUMPER WIRE
SOLDERING IRON
at sempre ang unit na gagawin ( sample unit: OPPO A11W )
simulan na po natin
connet muna ang direct emmc pinout ( nasa C:\Program Files\Z3X\EASYJTAG\PinoutsEMMC ) na po yan lahat
run easy jtag tool
goto emmc tool tab
goto emmc HW partitions
check ENH GP1 to GP4
check WR_REL GP1 to GP4
put CONFIRM as a password
click write to extCSD
disconnect jtag lines
assemble phone and fullflash with your tested fimware
hangang sa muli at sana ay maging gabay ang post na ito
alam ko po marami na sa mga master natin ang nakaka alam nito, ayaw lang i post para iwas PD, kaya naman pakiusap po, kunting pagpapahalaga lang po sa ating hanap buhay.
TESTED SOLUTION FOR MTK OPPO DEVICES LIKE A11W, R831K, R1001, R2001,R827, R1201 AND OTHER OPPO MTK DEVICE
TOOLS NEEDED
Z3X EASY JTAG WITH DIRECT EMMC ADOPTER
MAGNETIC WIRE OR JUMPER WIRE
SOLDERING IRON
at sempre ang unit na gagawin ( sample unit: OPPO A11W )
simulan na po natin
connet muna ang direct emmc pinout ( nasa C:\Program Files\Z3X\EASYJTAG\PinoutsEMMC ) na po yan lahat
run easy jtag tool
goto emmc tool tab
goto emmc HW partitions
check ENH GP1 to GP4
check WR_REL GP1 to GP4
put CONFIRM as a password
click write to extCSD
disconnect jtag lines
assemble phone and fullflash with your tested fimware
hangang sa muli at sana ay maging gabay ang post na ito
