WELCOME!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

[REFERENCE] U800 Logo and restart Done by Flashing using Riff Box..

Online statistics

Members online
1
Guests online
333
Total visitors
334

BLIND

Registered
Joined
Dec 23, 2014
Messages
2,965
Hi.. gusto klang e share ang isa sa makulit na U800, kahit ilang besis e flash sa Z3x at sa Multiloader at kahit anung version ng firmware ganun parin.. hayzzzzz...

Problem: Logo only and restart

1st. DL mo eto.. U800 DCC file.

Procedure:
Dismantle ang unit at e pinout tulad nito...



DSC07506.jpg


Open Riff Jtag manager.. Go to Jtag read\write and click analyze Jtag Chain para malaman if connected na ang unit. tulad nito..


.
u800.jpg


pagkatapus click ang DCC read\write Click main to load file.. see pix below sa tamang settings..


U800_procedure.jpg


click write flash.. at mag hintay.. medyo matagaltagal din ang flashing.



U800_1.jpg




u800_2.jpg



u800_success.jpg


Connecting to the dead body...OK
Detected dead body ID: 0x100D00E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is 800 kHz
Settings Code: 0x21010500000000000000000008000000

Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0098/0x0079 (128MB)

Writting FLASH1 memory from 0x000000000000 to 0x000007FFFFFF
Completed in 00:36:04.625 (Average Transfer Rate: 62.44 kB/s



DSC07508.jpg


ayus at sa wakas nag success din..
 
Back
Top