Model: SM-G930W8
Android version: 7.0
Product code: SM-G930WZKATLS
Phone version: G930W8VLS3BRA2
PDA version: G930W8VLS3BRA2
CSC version: G930W8OYA3BRA2
CSC country code: Canada
CSC sales code: TLS
HW version: REV0.2
Phone SN: R58J3161LTR
Chip name: EXYNOS8890
Modem board: SHANNON335
Security patch: 2018-01-01
RF cal date: 20170306
hindi kaya ng BOX
Dear Sir!
The problem is that you have a very new firmware on your phone:
PDA Version: G930W8VLS3BRA2 [january 2018, rev2]
Phone Version: G930W8VLS3BRA2 [january 2018, rev2]
CSC Version: G930W8OYA3BRA2 [january 2018, rev2]
And this firmware has binary :3
If your phone with the latest firmware Do not try to downgrade !!
You can not downgrade AP SW REV because if you are in Binary security bit 3,
You can only flash firmware with Security bit 3 !! G930W8XXX3XXXX like this.
With SW REV That you can not downgrade.
You can not downgrade this new firmware.
If you flash any older sboot than you will get binary error because of Samsung roll back protection on this very new firmware!
If you flash any older modem than you will get UNKNOWN BASEBAND. However, writing new modem will again get back to you the baseband.
SAMFULLFLASH KEY NGA
Searching for SAMSUNG Mobile USB Modem...OK
SAMSUNG USB Modem detected on [COM31]
Looking for DEVICE...OK
Reading USB MODEM information...OK
MODEL : SM-G930W8
VER : G930W8VLS3BRA2/G930W8OYA3BRA2/G930W8VLS3BRA2/G930W8VLS3BRA2
IMEI : 356252078417703
S/N : R58J3161LT
U/N : CE0117112D6E540
Connecting to DEVICE in DL-Mode...OK [COM10]
Setting up module...OK
Initializing memory...OK
Transmitting data...OK
Restarting DEVICE to AT-Mode...OK
Searching for SAMSUNG Diagnostic Port...[COM30]...OK
Connecting to phone via DIAG port...OK
CP Chip ID : 0x0335
Reading data from CP chip...OK
Calculating security...[KEY:OK]...OK
Sending data to SERVER...OK
Waiting for SERVER response...OK
UNLOCKED DONE BAWAL PD 2500 SINGIL