s5360 (galaxy Y) Logo Only Done By AntSOft!

[Ellise]

share ko lang mga boss pang bwena mano po


model: S5360

Flash Sa Ant Software

<ID:0/036> Added!!
<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> DefaultCalDataWithBoot_S5360XXKI6_REV05.tar.md5 is valid.
<OSM> PDA_S5360XXKI6_REV05.tar.md5 is valid.
<OSM> MODEM_S5360XXKI6_REV05.tar.md5 is valid.
<OSM> GT-S5360-MULTI-CSC-OXXKI6.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/036> Odin v.3 engine (ID:36)..
<ID:0/036> File analysis..
<ID:0/036> SetupConnection..
<ID:0/036> Initialzation..
<ID:0/036> Set PIT file..
<ID:0/036> DO NOT TURN OFF TARGET!!
<ID:0/036> Get PIT for mapping..
<ID:0/036> Firmware update start..
<ID:0/036> BcmBoot.img
<ID:0/036> NAND Write Start!! 
<ID:0/036> HEDGE_NVRAM8_RF_LE.bin
<ID:0/036> sysparm_dep.img
<ID:0/036> Sbl.bin
<ID:0/036> boot.img
<ID:0/036> system.img
<ID:0/036> userdata.img
<ID:0/036> param.lfs
<ID:0/036> BcmCP.img
<ID:0/036> Transmission Complete.. 
<ID:0/036> Now Writing.. Please wait about 2 minutes
<ID:0/036> Receive Response form LOKE
<ID:0/036> csc.rfs
<ID:0/036> RQT_CLOSE !!
<ID:0/036> RES OK !!
<ID:0/036> Completed..
<OSM> All threads completed. (succeed 1 / failed 0)
<ID:0/036> Removed!!

Done: 350 lang po

 

[thugz2014]

Sana sa sunod sir lagyan natin ng procedure at screenshot para medyo masundan ng iba satin na nangangapa pa .><

 

[Ellise]

Sana sa sunod sir lagyan natin ng procedure at screenshot para medyo masundan ng iba satin na nangangapa pa .><

eto po pala procedure sa pag flash using ant software flasher

enter nyo po sa download mode ang unit

(S5360 Download mode procedure:Simultaneously press Volume Down + Home + Power Key)

open antsoftware
select po yong samsung
select flasher
select phone model -(s5360)
click po ang run flasher

after po nun load nyo na po ang firmware....

start flash

wait until done po...

salamat