Torque Droidz Push + Hang on Logo Done w/ Complete Procedure & Firmware Inside

[disc cloner]

Magandang Araw po sa ating lahat mga Ka-ANT
Share ko lang po gawa ko ngayon

TORQUE DROIDZ PUSH +

PROBLEM: Hang on Logo

SOLUTION: Flash STOCK FIRMWARE using PHOENIXSUIT

PROCEDURE:

1. Kailangan po muna natin i-install yung PhoenixSuit Software.Kasama
na rin po sa PhoenixSuit Software yung USB Drivers pag ininstall nyo.

2. Proceed to FLASHING na po tayo.

3. Buksan po PhoexSuit Software.Then TICK FIRMWARE TAB tapos ilagay
po STOCK Firmware.

4. Power OFF UNIT.Bago nyo po isalpak USB CORD, HOLD Volume + or UP button po.

5. While holding Volume +/UP Button, Connect USB CORD to UNIT and simultaneously press
POWER Button hanggang sa madetect po yung UNIT sa Computer nyo.Huwag nyo po
bibitawan Volume BUtton hanggang sa walang nagpa pop-up.

6. Kapag may nag POP-UP na po pwede nyo na po bitawan volume button and stop pressing power button,
then Press YES.

7. Wait until flashing is done.

WORKING PO LAHAT YAN.

Eto po ginamit kong SOFTWARE & FIRMWARE

http://www.mediafire.com/file/mks5372z01608v7/PhoenixSuitV1.07_EN.msi

http://www.mediafire.com/file/68e5pwjdlyg1prk/DROIDZ_Push_+752A-1202.rar

PASSWORD PROTECTED PO YAN.Alam nyo na po gagawin.

SALAMAT PO SA PAG VIEW.HIT THANKS na lang po ok na po ako dun.



pass: XseLLize Gadgets Repair

 

[assasin21]

good day! pa sent po ng password...thanks

 

[disc cloner]

use triangle button boss.

 

[samsung35]

par pasend pass nito

 

[JIMROD]

pa pm po ng password mga master..

 

[JIMROD]

boss tested....thanks po..

salamat sa pag share...

 

[alexan]

use tatsulok for pass..

 

[Gen_303]

di pala naka report sa tatsulok ang pass

 

[disc cloner]

di pala naka report sa tatsulok ang pass

sir naka tatsulok na po password nyan.

 

[disc cloner]

makikisuyo po ng pass nito boss

boss nasend ko na po password