PROBLEM: frp after reset
SOLUTION: for hydra users only
BAKLASIN MUNA YUNG BACK CASE, PARA SA TESTPOINT.
PROCEDURE: (tingnan nlng yung img. kung di masundan)
1.open your main module , select your model , uncheck auto boot , select initialize factory mode (usb 1)
2.click execute , testpoint ang unit.
(install driver if needed, pag may nag pop-up click yes lng)
WARNING! wag tatanggalin yung usb cable sa unit.
3.go to partition manager , select factory/usb1 , click partitions tab.
4.go to factory reset protection ,
5.select FACTORY MODE SELECTION- REMOVE FRP then execute.
DONE!!
PROOF:
SOLUTION: for hydra users only
BAKLASIN MUNA YUNG BACK CASE, PARA SA TESTPOINT.
PROCEDURE: (tingnan nlng yung img. kung di masundan)
1.open your main module , select your model , uncheck auto boot , select initialize factory mode (usb 1)
2.click execute , testpoint ang unit.
(install driver if needed, pag may nag pop-up click yes lng)
WARNING! wag tatanggalin yung usb cable sa unit.
3.go to partition manager , select factory/usb1 , click partitions tab.
4.go to factory reset protection ,
5.select FACTORY MODE SELECTION- REMOVE FRP then execute.
DONE!!
PROOF:
