BlackBerry 9300 display problem...Done! [SOLVED]
May tanggap ako bb9300 white screen no display
Action taken:
change new lcd same version
change LCD connector,but still same no luck
[FONT=&]Fault desciption:[/FONT]
[FONT=&]Blackberry 9300 sometime had a strange problem that we can’t see display light on LCD. This problem occurs due to problem in LCD or sometime in LCD IC and track missing from display transistor to LCD connector.
[/FONT]Fault solution:
For this problem we have to use hardware methods for quick solution. So apply these steps one by one:
1. First change new lcd an then check light
2. If no solution then we have to use hardware technique as step 3
3 Open mobile PCB and check line continuity from LCD connector second point to display transistor IC as shown with yellow line in image below. If line missing there then apply jumper shown below:
4. After this check line from first point of LCD connector to resistance as shown in image with red line and if line missing there then apply jumper as shown in image in red line.
After applying both jumpers we will see proper display light on LCD without any problem.
Done.
May tanggap ako bb9300 white screen no display
Action taken:
change new lcd same version
change LCD connector,but still same no luck
[FONT=&]Fault desciption:[/FONT]
[FONT=&]Blackberry 9300 sometime had a strange problem that we can’t see display light on LCD. This problem occurs due to problem in LCD or sometime in LCD IC and track missing from display transistor to LCD connector.
[/FONT]Fault solution:
For this problem we have to use hardware methods for quick solution. So apply these steps one by one:
1. First change new lcd an then check light
2. If no solution then we have to use hardware technique as step 3
3 Open mobile PCB and check line continuity from LCD connector second point to display transistor IC as shown with yellow line in image below. If line missing there then apply jumper shown below:
4. After this check line from first point of LCD connector to resistance as shown in image with red line and if line missing there then apply jumper as shown in image in red line.
After applying both jumpers we will see proper display light on LCD without any problem.
Done.