cherry mobile w7 read code by vulcano

[UserData]

cherry mobile w7 read code by vulcano

unit: cherry mobile W7
status: lock code

tools
vulcano box
jig P-07A

procedure

A. connect vulcano box open GUI

must read vulcano manual

1- Go to Detect Tab
2- Select [D+/D-] Mstar (Do Find Boot) from Detect Type list
3- Inset cable to mobile
4- Press and Hold Power Button
5- Click on Detect Button
6- Volcano Will detect your phone like this
Detecting D+ and D-...
Vcc: 1
Gnd: 2 5
Detection initiated...
D+ = 6, D- = 8
Detection D+/D- with 19.63 seconds!
Continue to detect BOOT pin...
BOOT(Pull Down) = 3
New USB device: (VID_0E8D&PID_0003)
Detection completed.
7- Now Release Power Button and Click on Set Pinout
8- Press and Hold Power Button. Volcano Will detect like this
Setting pinouts...
Find USB device:MTK USB Port (COM60), (VID_0E8D&PID_0003)
9- It will detect MTK USB PORT. If you already installed Mtk usb drivers if you not installed it will ask you for drivers
10- Go to MTK Tab
11- Unclick Auto-Detect Pinouts
12- Click on Read Flash / Write Flash etc


B. read info
c. read flash
D. put read flashfile
E. check anyze code
F. RUN

DONE!

Click this bar to view the full image.

for reference only

 

[IVEST]

good job bro thanks for sharing