Cherymobile s100 all info here

FullFlash2014

Registered
Joined
Jun 12, 2014
Messages
4,477
Reaction score
241
Points
381
Location
Baguio City
cm flare s100 no imei done..w/procedure



cm flare s100 no imei done..w/procedure




u nid this first........cherry mobile flare imei writer - Download - 4shared

1. Install Tainyu HS-USB QRD 9025 port
to install just click start> my computer> properties> device manager>



2. Make sure phone is in USB DEBUGGING, MTP / USB Storage disabled.
3. Connect Flare to PC.
4. open Qualcomm_Modem_Tools_V1.1.2
5. Use Tainyu HS-USB QRD 9025 port number see image below




click write imei 1 then w8 reboot.....



click write imei 2 then w8 reboot.......



done..............................






tnx......for reference only............................
 
CM flare hang logo done sa ATF


MODEL
Cherry mobile S100 aka flare

STATUS
Hang logo




HISTORY
bigla nalang daw ayaw mag open

Una ginawa ko hard reset pero no luck
dati nakagawa na rin ako ng ganitong status
ang ginawa ko update ko sa jelly bean na ok naman,para maiba nmn
naisip ko subukan ko kaya sa atf jtag wala naman mawawala kung susubukan..:P
baklas ko agad xmpre need ng pinout

ito ang pinout sa jtag





TOOLS
-atf box jtag activated
-usb 5310
-modified cable

PROCEDURE
-select phone
-reset jtag
-restore boot

hintayin matapos almost 1hr... :D

SREENSHOT




DONE

 
flare s100 dead.....done w/procedure


flare s100 dead.....done w/procedure



needed.....

QPST 2.7 build 399 -
QPST-2.7.399


JB drivers -
JB_pcdrivers

Jelly Bean BP Firmware
BP_JB_Firmware

Download this 4 parts of "Firmware" "Flasher" Manual" "Drivers" are located inside the links below.

1.Jelly Bean 4.1.2.part1
2.Jelly Bean 4.1.2.part2
3.Jelly Bean 4.1.2.part3
4.Jelly Bean 4.1.2.part4

password....givecredits

open emmc downloader select bp firmware.......



w8 until finish or success ......



after success ....logo only.....



open again emmc downloader select wdcma v1011...




then next open qualfast2.0.5 select 8572 v006031



w8 lang until color blue then clik ok....



after color blue unplug usb then press vol. up and power buttom until mag color green xa....then insert again usb....





after finish logo only.....format press vol .up and power buttom w8 lng until color red then bitawan w8 nio lumabas recovery mode....

finish .....bawal ang sad dapat happy.........





reference only.........................tnx



 
Cherry Mobile flare ( s100 ) Deadboot Solution




Cherry mobile Flare
A.K.A ( FLARE)




kmhr.jpg




Sorry sa lahat ng Nag antay, maxado po kasi tayung busy mga bossing ito na po:tgy


Solution For Deadboot



Download first this Files bago tayu mag simula

QPST 2.7 build 399 -

QPST-2.7.399.rar

JB drivers -
JB_pcdrivers.rar

Jelly Bean BP Firmware
note: just pm me sa firmware kung succesful ang pag repair ng boot ng flare nyo....:tgy



WARNING : Supported ito sa mga flare na nadedetect pa ng Pc if hndi ito ma detect sa pc dont do this anymore

Install QPTS (alam ko pamilyar kayo jn.. ginagamit yan sa mga broadband stick..)
install lahat ng drivers para walang aberya


Install drivers

1. Connect deadboot flare to PC / Laptop.

2. Go to device manager, expand PORTS (COM & LPT). Check if there is an item called Qualcomm HSUSB QDLOADER 9008. If the item is there, you are done with driver install. If it does not exist, proceed to step3.

3. If there is no item under PORTS (COM & LPT), check device manager under OTHER DEVICES > Unknown Device

4. Double click UNKNOWN DEVICE > UPDATE DRIVER > BROWSE MY COMPUTER > browse to the folder where you saved extracted the ICS / JB drivers. It will install the driver, if it prompts for unsigned drivers, press INSTALL ANYWAY.

5. It should now be listed under COM PORTS > Qualcomm HSUSB QDLOADER 9008.

Run QPST and reprogram EMMC (dito tayu mag sisimula)

1. Run EMMC SOFTWARE DOWNLOAD.

2. Press BROWSE, it will detect your phone. Look for the PHONE TAB that says DOWNLOAD. Press OK.

3. Put check mark on PROGRAM BOOTLOADERS, PROGRAM MMC DEVICE, TRUSTED.

4. Under FLASH PROGRAMMER FILENAME, enter MPRG8X25.hex

5. Under BOOT IMAGE, enter 8X25_msimage.mbn

6. Press LOAD XML DEF > navigate to your extracted JB firmware > select rawprogram0 > press OPEN.

7. Press LOAD PATCH DEF > navigate to your extracted JB firmware > select patch0 > press OPEN

8. PRESS DOWNLOAD



9. An warning message may appear, TIME OUT WAITING etc etc or COOKIE NOT RECEIVED. If the error is TIME OUT WAITING, press OK and then press SWITCH DEVICE TO DLOAD. Check the flare, it will show RESET FOR ENTRY QPST.


10. Exit EMMC SOFTWARE DOWNLOAD. Proceed to flash Jelly Bean BP Firmware and then flash Jelly Bean img dump...



11. IF ERROR IS COOKIE NOT RECEIVED, sorry it is still bricked.


4gg0.jpg



after Program makikita nyo nalng na may lalabas na "REPAIR ENtRY QPST " or what bsta once na lumabas na ang ENRT QPTS ENTRY " proceed na kau sa Pag install ng JELLY BEAN





Good luck nalang po sa mga gagamit....


Note:Hindi ko pa tested ang sulotion na ito dahil dito "11. IF ERROR IS COOKIE NOT RECEIVED, sorry it is still bricked"

kaya hindi ko nalang tinuloy sa pag gawa ang tanggap kong flare,share ko nalang baka makatulong pa sa iba!!!



Hit thanx button kung nakakatulong mga idol...​
 
Cherry Mobile s100 TMPA Hard Reset done!!!




Step 1.Hold Volume Up + Power On
W8 for a few minutes. Green Screen wait until the red screen is upper.




Step 2. then Release the Volume Up and press Power On.
Step 3. use Volume up & down to scroll & locate Wipe date/Factory reset.
Step 4. Press Power On to Select then Select yes use Power on to ok...
Done!!!!







Finish...
 
Ok ok ok thanks sa lahat ng posters

wala na po kayo hahanapin dyan

nasa isang thread nalang


WELLCOME TO ANAK NG TINAPAY:banana:banana:banana:banana
 
tanung lng boss..anu po pinagkaiba ng dead sa deadboot?tanung lng po cnxa newbie lng po...salamat
 
HI Pa help nmn po !
di po kase nag tutuloy yung recovery mode ng CM s100 ko
mag gigreen tpos mag rered then tuloy tuloy sya sa pag open di sya nag rerecovey mode
what should i do ?
help please ?? :(
 
pano po yung solution sa flare s100 na ayaw gumana ng rotation kht naka on na yung rotation nya .. tnx po
 
Who read this thread (Total readers: 0)
No registered users viewing this thread.
Back
Top