REFERENCE FLARE Y3 MINI (FRP DONE) BY CM2SP2

[mahidfox]

share ko lang po ito tanggap ko flare y3 mini ginawa ko po kay cm2sp2 upd8 cpu flatform is SC7731E_BASE. then punta na kay service. to proceed it. vol up ang boot key po nito bago isaksak ang usb. remove first battery then salpak ulit tpos saksak usb na po. pag nka format with frp
pls like and feedback po if nagawa rin po ninyo thanks.

Operation : Format FS / Reset Settings [ v2.01 ]
Mode : Reset FRP

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device ...

Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731E_BASE : SC7731E_eMMC_1GB_RS
Sending Init Boot ...
Boot sent!
Kick FDL ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : Control transfered!

Boot Done!

Wipe Ok : FRP

Reconnect Power/Cable!


Done!
Elapsed: 00:00:33

 

[Yetbo09]

good am. boss may back up kba nito? need ko san. thank u...