Procedure:
-Flash in 3utool
-Turn in to DFU Mode
-Insert Cable in your laptop or desktop
-See if the device is already read
-Update driver in "Apple Mobile Device (DFU Mode)"
-Disconnect the cable and insert cable in Arduino Uno and insert into your desktop or laptop
"Make sure the device is still in DFU mode"
-Open iLintek then Select exact model and proper port
-Then Select "ARDIUNO PWND DFU"
-If the device already detected disconnect the arduino into your laptop and disconnect the cable of device in arduino then insert again in to your laptop
-Then check the device manager if still in Apple Mobile Usb (DFU Mode) driver
-If driver is correct go to iLintek then click DETECT PWND DFU Device
-If already read Go to A5/A6 Ramdisk Bypass then select Load ramdisk
-If the device already load click bypass then wait the device reboot
Thats all thank u.
-Flash in 3utool
-Turn in to DFU Mode
-Insert Cable in your laptop or desktop
-See if the device is already read
-Update driver in "Apple Mobile Device (DFU Mode)"
-Disconnect the cable and insert cable in Arduino Uno and insert into your desktop or laptop
"Make sure the device is still in DFU mode"
-Open iLintek then Select exact model and proper port
-Then Select "ARDIUNO PWND DFU"
-If the device already detected disconnect the arduino into your laptop and disconnect the cable of device in arduino then insert again in to your laptop
-Then check the device manager if still in Apple Mobile Usb (DFU Mode) driver
-If driver is correct go to iLintek then click DETECT PWND DFU Device
-If already read Go to A5/A6 Ramdisk Bypass then select Load ramdisk
-If the device already load click bypass then wait the device reboot
Thats all thank u.
