LG GS390GO unlock done w/pin out<

[arvhi]

procedure;

1.gw300 cable
2.open z3x lg sgold3 tool
3.tick uart
4tick connect,attach the cable ,
then insert battery,then press power button.



Welcome to LG Infineon SGOLD3 TOOL v2x by NoName®
Models count: 73
Current OS : Windows XP
Welcome to Sgold3 Module!!
Count supported models - 73
Disconnected.
Loading module , please wait...
PMB8877 Module 1.2 started. SW: Ver 2.2.7.2
Connecting to GS290GO in UART Mode (COM7 ,921600)
Please reconnect battery, press and hold power button...
Phone found! (MCU:UNK:FF) prebooting...
Release power button. Booting...
Preloader answer failed...
Please reconnect battery and try again or change speed
BOOT Failed
Disconnected.
Loading module , please wait...
PMB8877 Module 1.2 started. SW: Ver 2.2.7.2
Connecting to GS290GO in UART Mode (COM7 ,921600)
Please reconnect battery, press and hold power button...
Phone found! (MCUMB8877) prebooting...
Release power button. Booting...
Reading info...
BOOT Stage Finished , sending authority...
Sending SEC pack...
Reading EEPROM...
Backup Saved AS:C:\Program Files\Z3X\LG\LGI_SG3\BACKUP\GS290GO_autobackup_240 72010_145014.eep
Analising EEPROM...
Phone IMEI:012196000067142
Unlock codes:
NCK[0]: 3136407310750748 (LOCKED)
Finished in 5 seconds


5.then after that put any sim on the phone
6.then enter the unlock code.

in my case i dont have gw300 cable
so i used the pin out

 

[minstunmcphil]

happy unlocking bro congrats ..