REFERENCE myp1 hang up done by cm2sp2

[jethcell]

mates share ko lang gawa ko ngayon
open cm2sp2
choose sc7731e
choose reset setting frp
then format
done

heres the logs

Card found : 8CED3251 , v0147
Infinity-Box Chinese Miracle II : SPD/USC Module [SP2] v2.11

Load IDBase v8331 Ok!


Operation : Format FS / Reset Settings [ v2.11 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device ...


>>> Device not found!
>>> Remove battery, cable. Check cable and connection. Repeat operation!

Reconnect Power/Cable!

Operation : Format FS / Reset Settings [ v2.11 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device ...

Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731E_BASE : SC7731E_eMMC_1GB_0S
Sending Init Boot ...
Boot sent!
Kick FDL ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : 0x0008
FDL : EMMC_RO : False ; EMMC_PART : True ; EMMC_RPMB_SET : False
FDL : RAW : 0x0002
FDL : FLH : 0x400000
FDL : Control transfered!

Boot Done!

Wipe Ok : UserData
Wipe Ok : Cache
Wipe Ok : FRP

Reconnect Power/Cable!

Done!
Elapsed: 00:00:42

heres the pic