N7100 Deadboot Revived by Repairing EMMC

[Seya]

Problem

Dead after Flash

Action Taken
Repair boot using SD card sad to say always failed
Repair boot using Emmc direct by Easy Jtag But can't connect I got this error message

"Can't init device, Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]"

I'd rather use pull up resistor, but can't connect same error message

Solution:

We must use Testpoint to connect we need to remove Emmc
you can find Emmc TP in Easy Jtag installation folder

Connect all EMMC Lines [POWER, CLK, CMD, DAT0] and make short TP to GND

Successfully Dectected Remove TP to GND

Check EMMC name is "00000" We need to repair this

Advance Option Tab
Custom Operation select

SAMSUNG: VTU00M NAME"00000" Repair

Flasher tab
Write ROM1/ROM2

Succes in Repairing EMMC we need to Reball then put it back (l:0 (l:0

Flashing Firmware Success

 

[derick21]

thanks boss completo recado.ganda paka gawa..thanks for shaing;..

 

[Djmac]

Ayos boss, ganda ng pagkaka gawa..

 

[Nold22]

Boss maraming Salamat po sa mga ganitong post.

 

[jonard_23]

boss pashare naman ng emmc jumper images mo

 

[ARKTIS]

nice sharing galing talaga ni SMOD

 

[Seya]

[fixed]

The image not found after photobucket update is now fixed..

 

[rexelens]

sir pwede attach ng pinout nya? yong sa cpu nalang...

 

[melton]

sir pwede attach ng pinout nya? yong sa cpu nalang...

meron po yan s support. click emmc pin out

 

[chanay]

pwede ba to sa mga deadboot na may kunting palo sa tester?

 

[J2MocinasGSM]

Lupit!!!! eto ang klasi ng post na dapat tularan..Kumpleto..

 

[jevy]

paano malalaman ang mga pin out niya?

 

[unthinkable]

tnx for sharing...

 

[verser09]

wow gusto ko matuto nito,, revive the dead,, galing ni smod seya

 

[tazmaniand21]

BOSS smod san po galing yung file na ginamit mo sa jtag sa z3x po or sarili mong dump file? pwede pa hinge po meron kasi ako dito deadboot and sira na emmc nya bumili nako bago baka masayang kasi pag nagkamali ako 1pc lang kasi binili ko.
Salamat.

 

[tazmaniand21]

lahat po ba ng may pinout sa emmc dapat e solder? or kahit isa lang bawat may kulay?

ayaw kasi mag connect sakit.