pasilip sa connection mga jtag user...

[Berdugo]

z3x easy jtag new user po...

nguguluhan po aq sa dami ng refferences online...

eto po problem connection galing jtag at board ng cp... pkita tama, or pkidagdagan kung kulang

CMD, CLK, DAT0, GND, VCCq at VCC... DIRECT CONNECTION po wlang adapter...

maraming salamat po...

 

[Seya]

if wala ka po molex adaptor you need to use 2 External Power Supply
kagaya ng Refference dito N8000 logo only done! via ( z3x jtag direct EMMC )




Kung wala namang 2 External Power Supply pwede rin po imodify ung Easy Jtag box
pero do it at your own risk

Here is the modification to supply the eMMC from the box

Remove R3, R6 and re-route the pins 17 and 19 to the internal regulators U7 and U6.
This means we will have

VCCQ 1.8V on pin 19
VCC 3.3V on pin 17



Warning

Tested ko na ung modification na yan pero void na ung warranty ng box
much better pa rin na gumamit ng adaptor

 

[Berdugo]

if wala ka po molex adaptor you need to use 2 External Power Supply
kagaya ng Refference dito N8000 logo only done! via ( z3x jtag direct EMMC )




Kung wala namang 2 External Power Supply pwede rin po imodify ung Easy Jtag box
pero do it at your own risk

Here is the modification to supply the eMMC from the box

Remove R3, R6 and re-route the pins 17 and 19 to the internal regulators U7 and U6.
This means we will have

VCCQ 1.8V on pin 19
VCC 3.3V on pin 17



Warning

Tested ko na ung modification na yan pero void na ung warranty ng box
much better pa rin na gumamit ng adaptor

Sir recommended adaptor? Locally mbibili?

Slamat sir sa pagsilip at advice.... appreciated....

 

[Seya]

try mo po inquire dito boss

Easy jtag molex adaptor

 

[Berdugo]

try mo po inquire dito boss

Easy jtag molex adaptor

Slamat ulit sir