s100 atf---PERM_WRITE_PROTECT: YES

[khail02]

problem: pag power on po logo tas welcome tone tapos blackscreen na
solution1: wipe via fastboot.<WALA NANGYARE>
solution2: flash ko sa Android_AIO_Flasher_1.40_by_Fonehacker < LOGO NALANG MATAPOS REBOOT>

D2 NA LALU LUMAKI PROB KO PAG JTAG KO
solution3: jtag via atf..
E2 LOGS

13:24:24 : 1. DO NOT USE THE PHONE"S BATTERY
13:24:24 : 2. Connect USB Cable to Phone
13:24:24 : 3. Connect the Soldered TP Connections to ATF Box
13:24:24 :
13:24:24 :
13:24:24 : Interface Reset OK!
13:24:24 : eMMC Access Type: SECTOR MODE
13:24:24 : eMMC Supported Voltage Range:
13:24:24 : 3.5-3.6V, 3.4-3.5V, 3.3-3.4V, 3.2-3.3V, 3.1-3.2V
3.0-3.1V, 2.9-3.0V, 2.8-2.9V, 2.7-2.8V, 1.9-2.0V
13:24:24 :
13:24:24 : CID : 90014A2058494E594816A13F50DC10DF
13:24:24 : CSD : D02701320F5903FFFFFFFFE78A4040E3
13:24:24 :
13:24:24 : eMMC Boot Information
13:24:24 : Revision 1.5 (for MMC v4.41)
13:24:24 : BOOT PARTITION : USER AREA
13:24:24 : PARTITION ACCESS : R/W USER PARTITION
13:24:24 : PERM_BOOT_CFG_PROT : DISABLED
13:24:24 : PWR_BOOT_CFG_PROT : DISABLED
13:24:24 : BOOT MODE : x1 SINGLE DATA RATE + LOW SPEED
13:24:24 : RESET BUS WIDTH : ENABLED
13:24:24 : eMMC FirmW UPDATE : DISABLED
13:24:24 : EMMC CACHE SIZE : 0 KB
13:24:24 : SUPER PAGE SIZE : 3584 KB
13:24:24 : HC ERASE GROUP SIZE: 512 KB
13:24:24 : USER AREA SIZE : 3875536896 BYTES
13:24:24 : BOOT PARTITION SIZE: 2048 KB
13:24:24 : RPMB PARTITION SIZE: 2048 KB
13:24:24 :
13:24:24 :
13:24:24 : eMMC Device Information
13:24:24 : Manufacturer ID: HYNIX
13:24:24 : Device Type : Embedded BGA
13:24:24 : Application ID : 4A
13:24:24 : Product Name : XINYH
13:24:24 : Product Rev : 1.6
13:24:24 : Product SN : A13F50DC
13:24:24 : Manufactured : January 1997
13:24:24 :
13:24:24 : Card Specific Data
13:24:24 : CSD_STRUCTURE : Extended
13:24:24 : SPEC_VERS : Version 4.1/4.2/4.3
13:24:24 : TAAC : 13 ns
13:24:24 : TRAN_SPEED : 4000000 KHz
13:24:24 : READ_BL_LEN : 512 Bytes
13:24:24 : C_SIZE : HIGH CAPACITY
13:24:24 : WP_GRP_ENABLE : YES
13:24:24 : WRITE_BL_LEN : 512 Bytes
13:24:24 : CONTENT_PROT_APP : NO
13:24:24 : PERM_WRITE_PROTECT: NO <---- NOT PROTECTED PA D2
13:24:24 : TMP_WRITE_PROTECT : NO
13:24:24 :
13:24:24 : Extended CSD Saved:
13:24:24 : 90014A2058494E594816A13F50DC10DF.ext_csd
13:24:24 : Backup Directory:
13:24:24 : D:\bup\mytools\atf\eMMC\EXT_CSD\
13:24:24 :
13:24:40 : Start Writing 0x0014CA20 Blocks at 0x00000000
13:24:40 : Partition Selected: USER AREA
13:53:50 :
13:53:50 : Total Elapsed Time 00:29:09
13:53:50 : Write Success!



PAG OPEN KO... WHITESCREEN NA

naicip ko BK un firmware gnamit ko download ako ng bago..
habang ng wait sa dload..

fllash ko ulitt sa Android_AIO_Flasher_1.40_by_Fonehacker <----NAKU YARE WHITESCREEN NA TALAGaa NO WELCOME TONE NA DIN


solution 4: flash ko n ung new firm biglang ganto na


14:46:42 : 1. DO NOT USE THE PHONE"S BATTERY
14:46:42 : 2. Connect USB Cable to Phone
14:46:42 : 3. Connect the Soldered TP Connections to ATF Box
14:46:42 :
14:46:42 :
14:46:42 : Interface Reset OK!
14:46:42 : eMMC Access Type: SECTOR MODE
14:46:42 : eMMC Supported Voltage Range:
14:46:42 : 3.5-3.6V, 3.4-3.5V, 3.3-3.4V, 3.2-3.3V, 3.1-3.2V
3.0-3.1V, 2.9-3.0V, 2.8-2.9V, 2.7-2.8V, 1.9-2.0V
14:46:42 :
14:46:42 : CID : 90014A2058494E594816A13F50DC10DF
14:46:42 : CSD : C1702D0FE83FFFFFFFFEF340839FFFFF
14:46:42 :
14:46:42 : eMMC Boot Information
14:46:42 : Revision 1.0 (for MMC v4.0)
14:46:42 : BOOT PARTITION : NOT BOOT ENABLED
14:46:42 : PARTITION ACCESS : R/W USER PARTITION
14:46:42 : PERM_BOOT_CFG_PROT : ENABLED
14:46:42 : PWR_BOOT_CFG_PROT : DISABLED
14:46:42 : BOOT MODE : x1 SINGLE DATA RATE + LOW SPEED
14:46:42 : RESET BUS WIDTH : ENABLED
14:46:42 : eMMC FirmW UPDATE : DISABLED
14:46:42 : EMMC CACHE SIZE : 0 KB
14:46:42 : SUPER PAGE SIZE : 1536 KB
14:46:42 : HC ERASE GROUP SIZE: 28672 KB
14:46:42 : USER AREA SIZE : 1476395008 BYTES
14:46:42 : BOOT PARTITION SIZE: 3584 KB
14:46:42 : RPMB PARTITION SIZE: 0 KB
14:46:42 :
14:46:42 :
14:46:42 : eMMC Device Information
14:46:42 : Manufacturer ID: HYNIX
14:46:42 : Device Type : Embedded BGA
14:46:43 : Application ID : 4A
14:46:43 : Product Name : XINYH
14:46:43 : Product Rev : 1.6
14:46:43 : Product SN : A13F50DC
14:46:43 : Manufactured : January 1997
14:46:43 :
14:46:43 : Card Specific Data
14:46:43 : CSD_STRUCTURE : Extended
14:46:43 : SPEC_VERS : MMCA
14:46:43 : TAAC : 3500 ns
14:46:43 : TRAN_SPEED : 300 KHz
14:46:43 : READ_BL_LEN : 32768 Bytes
14:46:43 : C_SIZE : HIGH CAPACITY
14:46:43 : WP_GRP_ENABLE : YES
14:46:43 : WRITE_BL_LEN : 16384 Bytes
14:46:43 : CONTENT_PROT_APP : YES
14:46:43 : PERM_WRITE_PROTECT: YES <-----------bilang ng YES.... D KO N MAFLASH.....
14:46:43 : TMP_WRITE_PROTECT : YES
14:46:43 :
14:46:43 : Extended CSD Saved:
14:46:43 : 90014A2058494E594816A13F50DC10DF.ext_csd
14:46:43 : Backup Directory:
14:46:43 : D:\bup\mytools\atf\eMMC\EXT_CSD\
14:46:43 :
14:47:04 : EMMC Connect Error
14:47:04 : Operation Cancelled...
14:47:04 : Total Elapsed Time 00:00:15
14:47:04 : ERROR: WRITE FAILED!











ANU KAYA TO. DKO NA MAFLASH

PANU KYA TO MA UNLOCK


CONTENT_PROT_APP : YES
PERM_WRITE_PROTECT: YES
TMP_WRITE_PROTECT: YES

 

[MisterG]

tirahin mo na sa atf jtag swak yan kuha ka rin ng flash sa support ng atf

 

[khail02]

tirahin mo na sa atf jtag swak yan kuha ka rin ng flash sa support ng atf

dna bos ma flash . retry lng nang retry

bk kc protected na ung ic...dko ttalaga alam bkt ng kkarooon ng yes ung perm

 

[khail02]

Update mo yung jtag mo sir

12.20 n gamit kko bos..
dnmn activated sa jtag atf ko..ung emmc lng ginamit ko bos

 

[bojs]

may pag-asa pa yan boss ang kailangan mo lang ay activated an ATF JTAG.

kung wala ka baka meron dyan sa kapitbahay mo.



br,
bojs

 

[RemliG]

kailangan activated sa JTAG ATF mo boss

puwede din sa Z3X EASY JTAG mo tirahin

buo pa eMMC mo

 

[reymz]

bos download ka EMMC downloader tapos download ka BP firmware put phone to ENTRY QPTS mode tapos salpak phone install drivers,,tapos tingnan mo anu no, ng port tapos lagay mo sa EMMC download browse BP frimware,click download,,, try molng bos,meron sna ako mga file nyan dito piro d kopa na Upload

 

[2weng14]

tama sila jtag mo lang sa atf na activate na ang jtag amo pasok yan wag lang magunknown ang emmc