Samsung J5 aka G570f FRP done in 1 min....

[mhelskie]

FRP reset via UART micro Cable

No Need enable ADB
No need combi firmware
No need Flashing

Just follow software instructions.

Welcome to Octoplus Box Samsung software version 2.7.7
-----------------------------------------------------------------------------------
To connect SM-G570F phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3. Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
Platform: Samsung Android
Selected port: COM1
Selected model: SM-G570F
Operation: Reset FRP - UART EMMC
Searching for UART interface.. COM5
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...OK
Reading data...
Checking operation...OK
Searching for UART interface.. COM5
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (1/4 attempt)..success
FRP / Reactivation lock is successfully reseted!
Performed by 2.7.7.1 Software version.
​