REFERENCE Ubislate 7cz privacy code done with cm2 1.26:-

NEKNEKs

Registered
Joined
Aug 27, 2015
Messages
586
Reaction score
8
Points
81
Code:
Operation : Clear UserLocks [Pin/Pwd/Pattern/FVLock/GoogleAcc] [ v1.26 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 5 ]
Sync...
Inital regs read done
Boot Info : 
BB_CPU_ID : 6571
BB_CPU_HW : CA00
BB_CPU_SW : 8D00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6571_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending 
NAND_ID : 00000000000000000000000000000000
eMMC_ID : FE014E4D4D433034473F99871CD190C7
DA Stat : v4.2 on BBID : 0x8B
DA Sent. Configure setting now ... 
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 00FE , OEM : 014E
[eMMC] : FLASH_INF : G40CM
[eMMC] : FLASH_CID : FE014E4D4D433034473F99871CD190C7
[eMMC] : FLASH_LEN : 0x00000000E6800000
INT RAM    : 0x00020000
EXT RAM    : 0x20000000
BOOT TYPE  : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

LSSA Ok!
LSSW Ok!
LSSS Ok!
LSSG Ok!
LSSK Ok!
Security Settings : Clear Ok!

[Info] : Android 5.x / MT67xx : If phone stuck on "Logo" 
1. Wait 2-3 minutes. Power Off phone by long press "Power" button
2. Power On phone again
3. Or wait up to 3-7 minutes, until phone start by itself
4. Also recommended reboot phone twice before start use it

Done!
Elapsed: 00:00:28
Reconnect Power/Cable!
 
Last edited by a moderator:
Who read this thread (Total readers: 0)
No registered users viewing this thread.
Back
Top