Not charging and dead batt issue..
Steps:
1. Check physical condition of charging pin. (Replace if there are signs of corrosion and pseudo soldered pins)
2. Check battery if minimum charging voltage is present (around 3.7V)
3. Check if around 5V voltage is present on the positive line of the charging pin.
4. In this case I checked the capacitor in the reference charging ways photo. Voltage is below the required 5V.
5. I had to put a jumper wire from the positive line of the charging pin to the capacitor included on the reference.
6. Since required voltage is now present, the charging line section is now complete.
Sana makatulong. Salamat mga ka pinoy!
Steps:
1. Check physical condition of charging pin. (Replace if there are signs of corrosion and pseudo soldered pins)
2. Check battery if minimum charging voltage is present (around 3.7V)
3. Check if around 5V voltage is present on the positive line of the charging pin.
4. In this case I checked the capacitor in the reference charging ways photo. Voltage is below the required 5V.
5. I had to put a jumper wire from the positive line of the charging pin to the capacitor included on the reference.
6. Since required voltage is now present, the charging line section is now complete.
Sana makatulong. Salamat mga ka pinoy!
